Forum Discussion

Strobely's avatar
Strobely
Active Contributor
2 years ago

Logmein Client no longer installing along side Control Panel

All of a sudden, for some reason, Logmein control panel is installing, but the client is not. Normally they both install at the same time. I have to run a repair on the install and then it installs t...
Windows
  • CS_HelpDesk's avatar
    CS_HelpDesk
    2 years ago

    Hi Strobely ,

    So, the client was installed but it wasn't showing, because of your command, correct?

     

    We have not received any information that there is a change in the installation of the software.  I would definitely open a support ticket for them to further investigate why this is happening.

     

    I had interpreted that you didn't want the client app to install. And if that is the case, during the installation process the code should be FORCESHOWCLIENT=0.

     

Strobely's avatar
Strobely
Active Contributor

CS_HelpDesk Can you show me documentation that shows this is the case?

I have always been using this command in this way. It is my understanding that setting showclient to 0 means that the client ui will not popup after the installation completes.

Has this been changed?

CS_HelpDesk's avatar
CS_HelpDesk
GoTo Contributor
2 years ago

Hi Strobely ,

So, the client was installed but it wasn't showing, because of your command, correct?

 

We have not received any information that there is a change in the installation of the software.  I would definitely open a support ticket for them to further investigate why this is happening.

 

I had interpreted that you didn't want the client app to install. And if that is the case, during the installation process the code should be FORCESHOWCLIENT=0.

 

  • ipguy's avatar
    ipguy
    New Contributor
    3 months ago

    Where can we find  a full list of CLI command line options like FORCESHOWCLIENT ?